JOB REQUIREMENTS: Read work orders or examine parts to determine partsor sections of products to be produced. Trim or remove excess material,using scrapers, knives, or band saws. Brush or spray mold surfaces withparting agents or insert paper into molds to ensure smoothness andprevent sticking or seepage. Engrave or stamp identifying symbols,letters, or numbers on products. ***** OTHER EXPERIENCE ANDQUALIFICATIONS: Job Description: Assist the molding Set-up Technician onthe molding presses to perform standardized work by maintaining propertemperature and set cycle time for molding Setups are made andmaintained by technicians, but operators can be removed and installmolds, along with maintaining the vacuum unit at a prescribed level Mustbe capable of recognizing defective materials, parts, and machinemalfunctions Keep molds clean and vents open; fiber brush molds on anhourly basis Load and operate wheelabrator/tumbler to remove flash/scales from parts for specified finish Carefully perform uniformcleaning that is necessary for molders to operate properly, avoidingdamage to or breakage of parts ***** APPLICATION INSTRUCTIONS:E-Mail a Rsum: [email protected] Fax a Rsum: 414-763-1740E-Mail a Work Application: [email protected] This positionis listed by a private employment agency. The agency is the legalemployer. No fee will be charged of the job applicant.